Phone line open 24/7 · Free to call Serving West Texas, the Panhandle & Central Texas
Texas › Cooling guides › AC not turning on
Cooling troubleshooting

AC not turning on? 7 causes and what to check

When the air conditioner won't start at all, the cause is often something simple — a thermostat setting, a tripped breaker, or a safety switch doing its job. Work through these checks before you pay for a service call.

  • Free to call
  • No obligation
  • Line open 24/7
  • Quote before any work

Common causes

  1. Thermostat settings or dead batteries. Make sure the thermostat is set to COOL and the setpoint is below room temperature. If the screen is dim or blank, replace the batteries.
  2. Tripped circuit breaker. Most central systems have two breakers — one for the indoor unit and one for the outdoor unit. Reset a tripped breaker once. If it trips again, leave it off and call a technician; repeated resets can damage the equipment.
  3. Power switch or outdoor disconnect is off. The indoor unit usually has a wall switch that looks like a light switch, and the outdoor unit has a disconnect box nearby. Either one may have been turned off during other work.
  4. Clogged condensate drain. When the drain line backs up, a float switch shuts the system off to prevent water damage. Look for standing water in the drain pan under the indoor unit.
  5. Failed capacitor. If the outdoor unit hums or clicks but the fan and compressor don't start, the capacitor is a likely suspect. Capacitors hold a charge even with the power off — this is a job for a technician.
  6. Worn contactor. The contactor is the switch that sends power to the outdoor unit when the thermostat calls for cooling. When it wears out, the outdoor unit may not start at all.
  7. Blown low-voltage fuse or wiring fault. A short in the thermostat wiring can blow the small fuse on the control board, leaving the whole system unresponsive. A technician can find the short and replace the fuse.

Smell gas or hear a carbon monoxide alarm? Leave the house first, then call from outside. If Atmos Energy is your gas company, its 24-hour leak line is 866-322-8667; otherwise call your gas utility or 911. Don't run the furnace again until it's been inspected.

When to call a pro

If the thermostat, breakers, power switches, and drain pan all check out and the system still won't start — or a breaker trips again after one reset — it's time for a diagnostic. Don't open the outdoor unit's electrical panel yourself.

A diagnostic visit typically runs $75–$150, capacitor replacement $150–$400, and contactor replacement $150–$350; see the full ranges in our AC repair cost guide.

Check the contractor before work starts

Texas requires air conditioning and heating contractors to hold a license from the Texas Department of Licensing and Regulation (TDLR). Before you approve a repair:

  • Ask for the contractor's license number — Texas HVAC contractor licenses start with TACLA or TACLB.
  • Look it up on the TDLR license search to confirm it's active.
  • Get the diagnosis and price in writing before work begins, and ask whether the diagnostic fee is credited toward the repair.

Find AC help in your city

Amarillo · Lubbock · Midland · Killeen · Waco · Temple

More troubleshooting guides

Furnace blowing cold air · Heat pump stuck on emergency heat · Furnace turns on then shuts off

Call (720) 719-5071Free · No obligation · Open 24/7